MARINE CHOCKING COMPOUNDS
Description
A two-component, 100% solids, high-strength, heat-resistant, pourable epoxy-resin chock designed to replace steel chocks for maintaining permanent alignment of industrial equipment and machinery.
Description
- Thin pour, depths of 1” or less
- High modulus and high compressive strength
- High heat-distortion temperature, 210˚F
- Maximum effective load-bearing area
- Lower thermal conductivity than steel
- Increased free-flow of air under equipment
- Excellent resistance to corrosion and degradation by water, oils, salts, non-oxidizing acids and most solvents
Basic Uses
- Marine bearings
- Reciprocating and centrifugal equipment
- Steam and gas turbines
- Pumps and motors
- Crushers, grinding mills, hoists
- Hydraulic presses and other equipment
- Marine engines & transmissions
CHOCKING INSTALLATION MATERIALS
Open-Cell Foam Damming
• Chocks Must Be Retained Within Forms Until Cured
• Forms Must Be Sealed Watertight At Joints
Jiffy Mixers
• Used To Mix Chocking Compounds
• Mix About 3-Minutes At A Slow Speed Of 200-300 Rpm
Release Agent
• To Be Sprayed On Bolts, Foam Damming Or Other Surfaces To Prevent Adhesion To Chock
• 13oz. Size
None.
None.
